How to verify the installation of ignition timing

How to verify the installation of ignition timing
Ways set ignition there are many, and check that it is correct – only one. The method is simple, requires no special equipment and special skills

2015-11-21 10:54:34 249

ignitionequipment specialcheck thatcheck that correctcheck that correct onlycorrect only

Ways to set the ignition there are many, and check that it is correct – only one. The method is simple, requires no special equipment and special skills Start the engine and warmed it up to operating temperature. Turn on the transmission and Aragonaise. On a flat stretch of road picking up speed about 50 km/h and fourth gear included. Dramatically push "to the floor" the gas pedal. Possible options for the behavior of the engine: — For 1-2 seconds the sound of "Catania fingers" or scientifically – detonation. Then the car starts smoothly and steadily gained speed. Congratulations – you from the first time correctly established moment of ignition! — The engine detonates not 1-2 seconds, and much more. The diagnosis of the ignition too early. Correct the fault by turning the housing of the interrupter-distributor 1 degree clockwise. — The engine does not detonate completely. The ignition is too "late" — turn the distributor by 1 degree counterclockwise. Perform the above settings on a until by sharp pressing the accelerator pedal the engine will respond briefly (1-2 seconds) detonation.


Related articles