How to check the correctness of the contactless ignition system

How to check the correctness of the contactless ignition system
Design feature contactless ignition system is its ease of maintenance and increased resiliency. How to diagnose BSZ?

2015-11-21 09:08:35 202

ignitionignition systemcontactless ignitioncontactless ignition systemwiring harnessdevice instant

Design feature contactless ignition system is its ease of maintenance and increased resiliency. How to diagnose BSZ?

the Use of "MD-1" for the diagnosis of Baranovichi machine-tool plant

For Troubleshooting contactless ignition system use the instant device diagnostics "MD-1 + AZ-1", which is a small plastic box the size of a matchbox, the ends of which there are two sockets for wiring harness BSZ and four indicators: "Emergency ignition", "D", "P" and "K". Disconnected the wiring harness connector from the switch and plug to the wiring device with an instant diagnosis. Turn on the ignition. The starter does not rotate. The led "P" illuminates when the ignition switch and the ignition relay is working. Led "K" illuminates when the ignition coil is working. Includes starter. The led "L" blinks when the Hall sensor is working.

the use of the emergency ignition system "AL-1"

In case of failure of the regular Hall sensor disconnected the wiring harness connector from the interrupter-distributor and connect it to the alarm unit plugs. Turn on the ignition, if the led "AZ" illuminates when the ignition emergency works. We start the engine and at a maximum speed of 90 km/h are moving to the nearest auto shop or service station.

setting the ignition timing using the "MD-1"

In addition to "classical" methods of installation of ignition timing, you can set the ignition using the device "MD-1". Weaken a nut of fastening of the breaker the ignition distributor. Disconnected the wiring harness connector from the switch and plug to the wiring device with an instant diagnosis. Turn on the ignition. Rotating the crankshaft with the key or using the starter set the slider to a position in which it will be sent to the contact face of the 1st cylinder on the distributor cap. Turning the breaker-distributor, fix the position of the distributor at which the led turns on "D". Tighten a nut of fastening of the breaker the ignition distributor.


Related articles